29
Basic Programming Setup
6-C.
Press
ACCEPT
to continue with Site ID.
Step 7 - Site ID
Note:
A text Site ID may be programmed via Hach's management software and an RS232
connection.
Creates an 1–8 digit site identification number. The site ID will appear on all data printouts.
This feature is useful when multiple sites are monitored using a single flow meter or if data
readings from multiple flow meters are collected.
7-A.
Next, the flow meter will display the Site ID screen.
7-B.
Enter the site ID using the numeric keypad.
7-C.
Press
ACCEPT
to continue to total flow units.
Step 8 - Total Flow Units
8-A.
Next, the flow meter will display the Total Flow Units screen.
8-B.
Set the Total Flow Units (gal, ltr, m
3
, af, cf) using the
CHANGE CHOICE
soft key. Total
flow units of measure are used whenever a total flow unit is displayed or logged.
8-C.
Press
ACCEPT
to continue to velocity direction.
Step 9 - Velocity Direction (only when logging velocity)
9-A.
Next, the flow meter will display the Velocity Direction screen.
9-B.
Set the Velocity Direction using the
CHANGE CHOICE
soft key.
The Velocity Direction feature adapts to a number of difficult sites that would otherwise
not be able to measure velocity properly (Upstream, Downstream, and Always Positive).
For more information see the Velocity-Only Sensor Instruction Sheet (Cat. No. 88006-89).
9-C.
Press
ACCEPT
to move to velocity units setup.
9-D.
Set the velocity units (fps, mS) using the
CHANGE CHOICE
soft key.
11:00 AM 21 - APR - 01
SAMPLER PACING
ACCEPT
CHANGE
UNITS
SAMPLER PACING
CLEAR
ENTRY
500 gal
CANCEL
(USE NUMERIC KEYPAD)
Table 10 Flow Unit Choices
Abbreviation
Volume
gal
gallons
ltr
liters
m
3
cubic meters
af
acre-feet
cf
cubic-feet
Summary of Contents for Sigma 950
