105
Appendix D Programming Worksheet
Basic Programming Guidelines
•
Go through all Setup menu items and configure each.
•
Next, review the items in the Advanced Options menu and configure any items
needed.
•
Always check Data Logging and Totalizer Setup. Data logging channels must be
enabled if you want to record the data in memory. Also, the totalizer should be
configured with an acceptable scaling factor for the flow rate at each site.
•
Go to the options menu and set the time and date if not already set.
•
When finished, press the
RUN/STOP
key to start the program.
•
Photocopy the following worksheets to record your program settings at each site for
easy reference.
SETUP MENU
From the Main Menu, select
SETUP
,
MODIFY ALL ITEMS.
1.
Select FLOW unit of measure (gps, gpm, gph, lps, lpm, lph, mgd, afd, cfs, cfm, cfh,
cfd, cms, cmm, cmh, cmd): __________
2.
Select LEVEL unit of measure (cm, m, in., ft): __________
3.
Select a PRIMARY DEVICE:___________
Flume: Type______________, Size__________________
Weir: Type______________, Size__________________
Nozzle: Type______________, Size__________________
Manning Formula:
Slope________, Roughness___________, Pipe Diameter___________
Power Equation:
K
1
=_________, n
1
=_________, K
2
=_________, n
3
=_________
Head vs. Flow
4.
Enable PROGRAM LOCK password: (Y / N) (
Password is always 9500
)
5.
Enable SAMPLER PACING: (Y / N):
Flow interval:__________, Flow unit of measure:___________
6.
Enter a SITE IDENTIFICATION:_________________________________
7.
Enter unit of measure for TOTAL FLOW (acre-feet, cubic feet, gallons, liters, cubic
meters):__________
Name:
Date:
Serial No.:
ID No.:
Program Software Versions for:
Flow Meter:
DTU:
InSight
Flo-Center
Summary of Contents for Sigma 950
