Analyzer modes
The analyzer functions in
Operating
mode or
Command
mode. In
Operating
mode the analyzer
performs standard actions such as measurement, calibration, etc. A limited number of parameters
can also be displayed using the scroll keys. In
Command
mode the analyzer can be programmed,
parameters displayed and analyzer functions tested. By default, the analyzer is in
Command
mode
when first switched on.
To enter
Operating
mode from
Command
mode, select
START
from the
MAIN MENU
.
To enter
Command
mode from
Operating
mode, press
Select
to display the
STOP
command, then
• if you only wish to display currently defined parameters, from the
STOP
command use the scroll
keys to select
READING
and press
Enter
for approximately 3 seconds.
• if you wish to program the analyzer or test analyzer functions, from the
STOP
command press
Enter
and then
Enter
again to confirm. Then use the scroll keys to select
PROGRAMMING
and
press
Enter
for approximately 3 seconds.
Displays
Numeric display
: This display shows concentration (default), potential or temperature
measurements.
Alphanumeric display
: This display provides messages on status and programming. Messages are
different according to the mode:
•
Operating
mode: The top line indicates units, measurement type and any activated alarms. The
bottom line indicates the analyzer status, e.g. calibration, titration, etc.
•
Command
mode: The top line indicates the main menu. The bottom line indicates submenus and
data settings.
Menu overview
MAIN MENU
The main menu gives access to the following functions:
•
STOP
- Pressing
Enter
causes the measurement process to stop immediately
•
START
- Pressing
Enter
initiates the measurement process
•
STAND-BY
- Pressing
Enter
puts the analyzer in standby
•
PROGRAMMING
- Program the analyzer (
Command
mode only)
•
READING
- View parameters (
Operating
mode only)
In
PROGRAMMING
or
READING
mode the following options can be selected using the scroll keys:
•
MEASUREMENT
- Titration parameters
•
CALIBRATION
- Calibrate the analyzer
•
ANALOG-OUT
- Analog output parameters
•
ALARM
- Alarm limit parameters
•
SEQUENCE
- Measurement mode
•
SERVICE
- Check the analyzer and accessory operations
•
CLEANING
- Chemical cleaning parameters
•
SAMPLE COND.
- Sample conditioning parameters
•
CAL PARAMETER
- View the primary and last calibration details
•
TIMING
- Titration cycle parameters
•
PM XXXX
- System configuration (only available in
PROGRAMMING
mode and requires a valid
password)
Note: Some of the above options are only available if the relevant accessory has been installed.
20
English
Summary of Contents for POLYMETRON 8810 ISE
Page 2: ...English 3 Deutsch 27 Italiano 53 Français 79 Español 104 Polski 130 Română 156 2 ...
Page 180: ......
Page 181: ......
