Hach Met One 6000 Series, User Manual, Page: 37 / 70

35
Operation
4.2.2.1 LAN setup
For configuration through a network, only the LAN settings can be changed. All other
settings must be changed through local setup by direct connection to the service port on
the counter or through a ModbusTCP connection.
1. In the utility program, select
LAN SETUP
. The LAN Based Setup window will be
shown ( Figure 24 ). The software will search for LAN instruments.
2. If LAN instruments are found, the instruments will be listed as shown in Figure 24 .
Select an instrument to show the LAN Instrument Settings.
3. Change the instrument settings if necessary. Refer to Figure 23 and Table 9 for a
description of the settings. When configured as necessary, click
SAVE SETTINGS
.
A ModbusTCP connection can be made where all the Modbus registers are available.
The user can then access all configuration options in the Modbus register map (refer
to
Appendix A on page 53 ).
Error messages
If an error message such as “Invalid IP setting” is shown, refer to Table 9 to find the
values that can be used. Enter a value in the range for the setting.
Figure 24 LAN setup for Ethernet units