I. Application
Portable rehabilitation tables enable the physiotherapist correct, safe and effective conduct of
rehabilitation treatment, physiotherapy, physical therapy, massage, aiming at treating or alleviating the
course of illnesses and the results of injuries /impairments. Used at the medical and doctor's offices, they
allow patients to adopt the correct posture for conducting effective and safe treatment or examination.
The construction of the rehabilitation tables enables the physiotherapist easy and complete access to the
patient from each side, thanks to which all various treatments produce desired results and ensure proper
conditions for the conduct of a treatment/examination.
II. Construction of the portable table
1
2
3
3
4
5
6
6
7
8
9
10
2
11
12
1.
Wooden table top covered with upholstery
2.
External legs
3.
External legs' spacers
4. System of cables
5.
Suitcase lock
6.
Transport handles
7. Knob
8.
Armrests (accessories)
9.
Headrest (accessories)
10. Arms front shelf
(accessories)
11.
Internal leg (in selected tables only)
12. Support system (only in Aero Stabila)
III. Operation
S
equence of unfolding the table:
1.
Open the lock (5) and turn the table tops aside on
Table in the folded condition constitutes a suitcase.
rubber transport feet (1).
2. Draw out the equipment (8, 9 ,10) from the table inside (if any).
3
and p
. Unfold the legs outside (2) maximally extended
ut the table on a hard and even foundation.
(Prior to loading the centre of the table top should be tilted up approx. 3 cm).
In tables with three pairs
of legs, inside legs 11 without load should be slightly raised off the ground and touch the ground when
they are loaded.
4. Check if the cable system is properly unfolded and does not catch on the structure
(
4
).
5.
Set the appropriate table height – depending on the table model description of all the
chart
activities is present in the
entitled ”Height adjustment”.
6.
Install the headrest (
9
) and the remaining equipment (
8
, 1
0
) (if any).
7.
Lifting of the mobile part of the table (A, B) takes place by means of: releasing the hook and loop
*
fastener, lifting on the required height.
8.
Lowering of the mobile part of the table (A, B) takes place by its maximum lifting and then
lowering it down and securing by means of hook and loop fastener.*
A.
Tables with
elevated backrest option
B. Table Xena
* regards table Xena and the tables with elevated backrest option
9
Chiro Ultralux 19
A
B
INSTRUCTION MANUAL
EN
9
