User Guide
TGT. 27.09.2017
Technical
Page 18 of 20
©Copyright by Habegger Maschinenfabrik AG
Version 02 / 27.09.2017
6
Faults
Faults
possible causes
Actions
Motor cannot be
started
Too little petrol
Single lever operation on motor set to stop
other causes
Refuel
Switch lever to start
see STIHL operating instructions.
Motor “dies” when
starting up
Altitude too great over approx. 2200 m
above sea level
Poor carburettor settings
Load is greater than permitted tensile force
Adjust carburettor
see STIHL operating instructions.
Reduce load or employ pulley block
The driving system
is not moving de-
spite the throttle
on the running
motor being open
Load is greater than permitted tensile force
Chain brake released (blocked)
Broken V-belt
Centrifugal clutch on motor worn out
Sliding clutch worn out
Sliding clutch misaligned
Brake driving plate cams broken
Hand crank cams broken
Brake (spindle) stuck in open position
Reduce load or employ pulley block pulling system
Release chain brake
Replace V-belt
Replace centrifugal clutch
Readjust sliding clutch
Adjust sliding clutch
Replace driving plate, product no. 07510
Replace handle grip, product no. 07190
Hold brake housing steady and turn hand crank in
hoisting direction
Rope is not moving
despite driving
wheel turning
Rope incorrectly inserted
too small or too thin rope
inserted
Rope severely worn out
Driving wheel or rope too heavily greased
Groove in driving wheel heavily soiled
no load on rope
Insert rope according to diagram
Insert correct rope
Insert new rope
clean
clean
Load rope
The tension in the
rope cannot be
relieved
Brake wet
Chain brake engaged
Return to HABEGGER for repair
Release chain brake
