Page 16
GRAY — CAR-FINDER
YELLOW — IGNITION
ORANGE — STARTER
INTERRUPT
GREEN — DOOR LOCK
BLUE — DOOR UNLOCK
WHITE + ALARM SENSE
CAR FINDER HORN/LIGHTS – This pulsating negative output may
need relay(s) to sound the vehicle’s horns or flash its parking lights.
For dual circuit parking lights connect a second light relay that is
driven off the first one, otherwise one relay for lights and one relay
for horns. Observe polarities.
IGNITON – This is a 12V current sensing input that connects to the
12V output of the vehicle’s ignition. Presence of 12V signal on this
input alerts the tracker when the vehicle is turned on and the key is
in the ignition.
THIS WIRE MUST BE CONNECTED FOR THE TRACKING
SYSTEM TO WORK PROPERLY.
Starter Interrupt (-) – The ORANGE wire provides a latched ground
output signal. When this feature is activated it will cause an optional
relay to open when an attempt is made to start the engine, thus
preventing the starter from operating until another signal is sent to
the Text-N-Track H1000 to remove the ground signal from the
ORANGE wire. This is designed specifically to interrupt starters.
DOOR LOCK COMMAND – This is a conventional NEGATIVE door
lock output designed to be connected to factory or aftermarket door
lock actuators.
This output may also be used for remote starters.
DOOR UNLOCK COMMAND – This is a conventional NEGATIVE
door unlock output designed to be connected via a relay to factory
or aftermarket door lock actuators.
THEFT ALARM – Theft alarm sense input – Alarm sounding devices
normally are powered by 12 volts positive, and are monitored by the
Haas GPS monitoring unit 12 volt positive input. When the sounding
device is powered for 15 or more seconds it causes the monitoring
unit to send an alert message to the owner. Should the sounding
device be negatively driven, use a relay to invert the polarity. To
prevent unintended messages from being sent, only one message is
sent to the customer.
CIRCUIT DESCRIPTION
