Haas Automation UMC-1000, Operator'S Manual Supplement

Page: 61 / 70

Setting Work and Tool Offsets
43
F6.8: UMC Z-Axis Work Zero Offset Start
1. Load the work probe into the spindle.
2. Make sure that the B and C Axes are at the same work zero point set earlier.
(
G00 G90 G54 B0 C0
). Refer to the Set the B-Axis Work Offset and Set the C-Axis
Work Offset sections if these values are not correct.
3. Set the X- and Y-Axis offsets using the standard WIPS templates as appropriate.
Refer to the WIPS manual for more information.
4. Position the work probe tip approximately 0.25" (6 mm) above the Z-Axis zero
surface.
5. Navigate to [OFFSET] Work . Scroll to the work offset value used in the program (
G54
in this example).
6. Press the [RIGHT] cursor arrow until you reach the
Probe Action
sub-menu.
7. Type
11
, and then press [ENTER] to assign the Single Surface Probe Action
to the offset.
8. Press [PART ZERO SET] to move to
VPS
.
9. Select the Z Variable.
0.25"
(6 mm)