STEP 2
Look at the indicator to see the amount and the direction of the error.
STEP 3
Loosen a small amount the (4) screws that attach the turret housing
casting [1] to the riser [2].
Note:
After you loosen the screws, tighten them enough to let
you control the adjustment, but keep them loose enough to let
you correct the alignment. This is approximately 5-10 ft-lb (7-14
Nm).
STEP 4
Tighten (1) screw to approximately 20 ft-lb (27 Nm) to use as a pivot in the
steps that follow.
Note:
Keep the pivot screw loose enough to allow the casting to
rotate, but tight enough to prevent unwanted movement.
Copyright 2018 by Haas Automation, Inc. No unauthorized reproduction | Last Published On November 05, 2015
32/67
