Haan SV-60, User Manual

Page: 15 / 32

You MUST use the Pad Tray
with the Ultra-Microfiber
™
Pads when using the SV-60
on hard surface floors.
Make sure you always start
with completely dry pads.
The pad will absorb moisture
as it cleans. Once it becomes
damp, replace it with a dry pad.
Never leave your Ultra-
MicroFiber
™
Pad on your
SV-60 Steam Vacuum when
you have finished using the
unit. Once the unit has cooled,
remove the pad before storing
the SV-60.
Always place your SV-60 on
the Resting Mat while it is
cooling down to protect your
floors.
Fig 19
Carpet Tray for Higher Pile Carpets:
Because the SV-60 Steam Vacuum does not have the
ability to adjust the height of the vacuum base, there
is an optional tray designed to accommodate higher
pile carpets.
To Attach the High Pile Tray:
1) Turn power OFF.
2) There are 4 raised buttons on the underside of
the base of the SV-60 that correspond to indents
in the top side of the High Pile Tray. (Fig 18)
3) Set the Pad Tray on the floor with the indents facing
up. Align the buttons and press together until you
hear the tray snap into place. You are now ready to
use the SV-60 on higher pile.
HaaN ultra-MicroFiber
™
Pads:
What is an ultra-microfiber?
An ultra-microfiber is a textile fiber that is thinner
than a microfiber. The Ultra-MicroFiber™ by HAAN
Corporation is 5-10 times thinner than common
microfiber providing for a significantly higher thread
count in the same surface area. The thinner and
higher the thread count, the greater the absorption.
HAAN’s ultra-microfibers are so thin that more dirt
and dust gets trapped between the fibers, making
your cleaning easier and less time-consuming. (Fig 19)
The ultra-microfiber pad is made up of multiple
layers of super absorbent material. The outer layer
is ultra-microfiber on one side and a “hook & loop”
system on the other side that attaches easily to the
underside of the steam head after the Pad Tray is
attached (see directions on pages 10-11). Simply place
the pad on the floor with the “hook & loop” side
up, and lightly press the SV-60 Steam Vacuum onto it.
As high temperature steam passes through a pad to
contact the floor to kill germs, molds and mites. It is
natural that the pad gradually absorbs moisture. After
a certain length of time, the pad repels water and
becomes damp. When the pad becomes saturated,
turn the unit OFF and wait until the unit cools down
for approximately 5 minutes. Put your foot on a corner
of the pad and lift the SV-60 off the pad. Replace
with a dry pad, turn the unit back on and continue.
To keep the floor clean and dry, replace the pad
when it is dirty and/or saturated.
Operating Instructions:
(cont)
www.
HAAN
USA.com 877-HAAN DIRECT / 877-422-6347 pg 13
5-10x
Thinner
than
Microfiber
Flax
Wool
Cotton
Silk
Microfiber
HAAN Ultra-Microfiber
ImPOrtant
Fig 18
www.sylvane.com 1-800-934-9194