H3C UniServer R2700 G3, User Manual, Page: 101 / 226

7-18
Figure 7-21 Removing a GPU module that is not connected with a power cord
{
If the GPU module is connected with a power cord, disconnect the power cord from the GPU
module. Then, open the retaining latch on the riser card, pull the GPU module out of the slot,
and disconnect the power cord from the riser card, as shown in
Figure 7-22 .
The removal procedure is the same for GPU modules that require a power cord. This
example uses the GPU-M4000-1-X GPU module to show the procedure.
Figure 7-22 Removing a GPU module that is connected with a power cord
6.
Install a new GPU module. For more information, see " Installing GPU modules ."
7.
Install the access panel. For more information, see " Installing the access panel ."
8.
Rack-mount the server. For more information, see " Rack-mounting the server ."
9.
Connect the power cord. For more information, see " Connecting the power cord ."
10.
Power on the server. For more information, see " Powering on the server ."