H3C UniServer R2700 G3, User Manual, Page: 52 / 226

6-16
Installing GPU modules
Guidelines
A riser card is required when you install a GPU module.
A GPU module comes with a GPU support bracket if it requires a power cord, as shown in Figure
6-24 . This support bracket is required for secure installation on some server models. On an R2700
server, you do not need to install this support bracket.
The GPU-M4000-1-X GPU module requires a power cord (P/N 0404A0M3).
Figure 6-24 GPU support bracket
Procedure
The GPU module installation procedure is the same for PCIe slots 1 and 2. This procedure uses
PCIe slot 1 as an example.
To install a GPU module:
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Remove the PCIe module blank from PCIe slot 1. Make sure its fastening screw is re-installed
upside down. For more information, see "
Installing riser cards and PCIe modules ."
5.
Install the GPU module in PCIe slot 1.
{
If the GPU module does not require a power cord, open the retaining latch on the riser card,
insert the GPU module into the slot, and then close the retaining latch, as shown in
Figure
6-25 .