47
Figure 50 8T1 splitter cable
Connecting an E1/T1 cable
Connecting an E1 cable (D15/D68 <----> BNC)
CAUTION:
When connecting the interface cable, pay attention to the mark on the interface to avoid wrong
insertion, which might damage the interface module or even the router.
•
If you do not need to extend the cable, you can directly connect the BNC connectors of the E1
75-ohm cable to the remote network device as follows.
a.
Connect the D15/D68 connector of the E1 75-ohm cable to the D15/D68 interface of the
interface module and fasten the bolts to secure the cable.
b.
The other end of the cable provides one pair or multiple pairs of 75-ohm BNC connectors.
Connect the TX connectors and the RX connectors on this end to the RX connectors and
the TX connectors on the remote device respectively.
Figure 51 Connecting an E1 75-ohm cable
•
If you want to extend the cable, connect each BNC connector of the E1 75-ohm cable to one
end of a coaxial connector, and connect the remote device to the other end of the coaxial
connector through an E1 75-ohm adapter cable.
……
