117
Table 42 Fiber Ethernet port specifications
Item Specification
Connector type
LC
Transceiver module type
SFP
Interface standards
802.3, 802.3u, and 802.3ab
Operating mode
1000 Mbps, full duplex
10 Gbps Ethernet port
The MCP-X2 provides two 10 Gbps Ethernet ports. 10 Gbps SFP+ ports do not support 1000 Mbps
transceiver modules.
Table 43 10 Gbps Ethernet port specifications
Item Specification
Protocol 802.3ae
Connector type
LC
Transceiver module type
SFP+
Physical layer
10GBASE-R/W
Transmission rate
•
LAN PHY
—10.3125 Gbps
•
WAN PHY
—9.95328 Gbps
10GBASE-R-SFP+ port
Item Specification
Connector type
LC
Transceiver module type
SFP+
Interface standards
802.3ae
Operating mode
10 Gbps, full duplex
Power button
WARNING!
The device might still have power after you press the power button. Do not reboot the RPE-X5E
MPU or remove power cords from the RPE-X5E MPU until the power button/LED goes off.
CAUTION:
•
Forced power-off might cause data loss in virtual machines. Please use it with caution.
•
Avoid accidentally pressing the power button when the device is operating. Doing so will power
off the device system and cause service interruption.
•
If a virtual machine cannot be shut down gracefully, log in to it, terminate the running processes,
and then shut down it.
The power button is used to power on or power off the Comware system and virtual machines
created on the Comware system.
To gracefully shut down the Comware system when the device is operating, press and hold the
power button for 0.5 to 3 seconds. To forcibly shut down the Comware system, press and hold the
power button for more than 3 seconds.
