167
SNMPv1/SNMPv2c configuration example
The SNMPv1 configuration procedure is the same as the SNMPv2c configuration procedure. This
example uses SNMPv1, and is available only for high encryption in non-FIPS mode.
Network requirements
As shown in
, the NMS (1.1.1.2/24) uses SNMPv1 to manage the SNMP agent (1.1.1.1/24), and
the agent automatically sends notifications to report events to the NMS.
Figure 53
Network diagram
Configuration procedure
1.
Configure the SNMP agent:
# Configure the IP address of the agent and make sure the agent and the NMS can reach each
other. (Details not shown.)
# Specify SNMPv1, and create the read-only community
public
and the read and write community
private
.
<Agent> system-view
[Agent] snmp-agent sys-info version v1
[Agent] snmp-agent community read public
[Agent] snmp-agent community write private
# Configure contact and physical location information for the agent.
[Agent] snmp-agent sys-info contact Mr.Wang-Tel:3306
[Agent] snmp-agent sys-info location telephone-closet,3rd-floor
# Enable SNMP notifications, specify the NMS at 1.1.1.2 as an SNMP trap destination, and use
public
as the community name. (To make sure the NMS can receive traps, specify the same SNMP
version in the
snmp-agent target-host
command as is configured on the NMS.)
[Agent] snmp-agent trap enable
[Agent] snmp-agent target-host trap address udp-domain 1.1.1.2 params securityname
public v1
2.
Configure the SNMP NMS:
{
Specify SNMPv1.
{
Create the read-only community
public
, and create the read and write community
private
.
{
Configure timeout time and maximum number of retries as needed.
For information about configuring the NMS, see the NMS manual.
NOTE:
The SNMP settings on the agent and the NMS must match.
