Manual version: 6PW103-20190312
BOM: 3123A1N8
v
2.
Remove the interface module from the interface switch module.
a.
Use a Phillips screwdriver to loosen the captive screw on the interface module until all
pressure is released.
b.
Open the ejector lever to disengage the module from the interface switch module, and then
pull the module slowly out of the slot along the guide rails.
3.
Place the interface module on an anti-static workbench or in an anti-static bag with its PCB
components facing up.
4.
If you are not to install a new interface module, install a filler panel in the slot to prevent dust and
ensure good ventilation.
Copyright © 2019 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.