Manual version: 6PW103-20190312
BOM: 3123A1N8
iii
Table 4 1000BASE-X SFP port LED description
Status Description
Flashing
The port is sending or receiving data.
On
A link is present on the port.
Off
No link is present on the port.
Table 5 40GBASE-R QSFP+ port LED description
Status Description
Flashing
The port is sending or receiving data.
On
A link is present on the port.
Off
No link is present on the port.
5 Installing or removing the interface module
CAUTION:
•
Wear a reliably-grounded ESD wrist strap or ESD gloves before you install or remove the
interface module.
•
Do not touch the components on the interface module.
•
The interface module is not hot swappable. You must first power off the device before installing
or removing the interface module.
5.1
Installing the interface module
To install the interface module on the device, you must first install the module on an interface switch
module.
To install the interface module:
1.
Install the interface module on an interface switch module.
a.
Place the interface switch module on an antistatic workbench with its PCB components
facing up.
If the interface switch module has been installed on the device, first remove it from the
device. For the removal procedure, see "
."
b.
Remove the filler panel from the target slot on the interface switch module.
c.
Insert the interface module slowly into the target slot along the guide rails.
d.
Use a Phillips screwdriver to fasten the captive screw on the interface module to secure it in
the interface switch module.