Manual version: 6PW103-20190312
BOM: 3123A1N8
iv
Figure 2 Installing the interface module on an interface switch module
2.
Install the interface switch module on the device.
a.
Open the ejector levers on the interface switch module and then push the module slowly
into the slot along the guide rails.
b.
Close the ejector levers to ensure that the module is in close contact with the backplane.
c.
Use a Phillips screwdriver to fasten the captive screws on the interface switch module to
secure the module in the device.
Figure 3 Installing the interface switch module on the device
5.2
Removing the interface module
To remove the interface module, first remove the interface switch module where the interface module
is attached from the device.
To remove the interface module:
1.
Remove the interface switch module from the device.
a.
Use a Phillips screwdriver to loosen the captive screws on the interface switch module until
all pressure is released.
b.
Open the ejector levers to disengage the module from the backplane, and then pull the
module slowly out of the slot along the guide rails.