24
Figure 29
Installing a power module (S5830-52SC)
Figure 30
Installing a power module (S5830-106S)
Removing a power module
CAUTION:
If the switch has two power modules, removing one power module does not affect the operation of the
switch. If the switch has only one power module, removing the power module powers off the switch.
To remove a power module:
1.
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded.
2.
Remove the power cord from the power module. When removing the DC power cord, squeeze the
tabs on the power cord connector with your thumb and forefinger and then pull the connector out,
as shown in
.
3.
Hold the handle on the power module with one hand, pivot the latch on the power module with
your thumb, and pull the power module part way out of the slot. Then supporting the power module
bottom with one hand, slowly pull the power module out with the other hand, as shown in
and
Put the removed power module in an antistatic bag.
Install a filler panel if no power module is to be installed.
