8-13
View
System view
Default Level
2: System level
Parameters
process-id
: RIPng process ID, in the range of 1 to 65535. The default value is 1.
Description
Use the
ripng
command to create a RIPng process and enter RIPng view.
Use the
undo ripng
command to disable a RIPng process.
By default, no RIPng process is enabled.
Examples
# Create RIPng process 100 and enter its view.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100]
# Disable RIPng process 100.
[Sysname] undo ripng 100
ripng default-route
Syntax
ripng default-route
{
only
|
originate
} [
cost
cost
]
undo ripng default-route
View
Interface view
Default Level
2: System level
Parameters
only
: Indicates that only the IPv6 default route (::/0) is advertised through the interface.
originate
: Indicates that the IPv6 default route (::/0) is advertised without suppressing other
routes.
cost
: Metric of the advertised default route, in the range of 1 to 15, with a default value of 1.
Description
Use the
ripng default-route
command to advertise a default route with the specified routing
metric to a RIPng neighbor.
Use the
undo ripng default-route
command to stop advertising or forwarding the default route.
By default, a RIP process does not advertise any default route.
After you execute this command, the generated RIPng default route is advertised in a route
update over the specified interface. This IPv6 default route is advertised without considering
whether it already exists in the local IPv6 routing table.
