12
irf isolate member
Use
irf isolate member
to isolate an unused IRF member ID.
Use
undo irf isolate member
to remove the isolation setting for a member ID.
NOTE:
This command is available in Release 1005P04 and later versions.
Syntax
irf isolate member
member-id
undo irf isolate member
member-id
Default
No member IDs are isolated.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
member-id
: Specifies an IRF member ID. Available values are IDs that have not been assigned.
Usage guidelines
This command is available only in IRF mode.
Before you assign an isolated member ID to a new member device, you must remove the isolation setting
for the member ID.
Examples
# Isolate IRF member ID 4.
<Sysname> system-view
[Sysname] irf isolate member 4
irf link-delay
Use
irf link-delay
to set a delay for the IRF ports to report a link down event.
Use
undo irf link-delay
to restore the default.
Syntax
irf link-delay
interval
undo irf link-delay
Default
The IRF link down event report delay is 4000 milliseconds (4 seconds).