H3C MSR810, Configuration Manual

Page: 25 / 36

19
Display and maintenance commands for RTC
terminal access
Execute displays commands in any view and reset commands in user view.
Task Command
Display terminal access information.
display rta { all | statistics |
terminal-number { vty-number |
brief | detail | statistics } }
Display states of all RTC client connections
accepted by a relay server.
display rta relay status
Display the forwarding statistics of a relay server.
display rta relay statistics
Clear statistics for a terminal.
reset rta statistics
terminal-number
Clear the packet statistics for clients connected to
the relay server.
reset rta relay statistics
Disconnect client connections from a relay server.
rta relay disconnect { server-id
client-id | all }
RTC terminal access configuration examples
Example: Configuring asynchronous TCP RTC one-to-one
Network configuration
As shown in Figure 4 , the RTC client and the RTC server are connected to the central terminal
device and the remote terminal device through Async 2/2/0.
Configure the RTC client and the RTC server to enable the central terminal to monitor the remote
terminal:
•
Set the listening number of the RTC server to 9000.
•
Set the terminal number to 1 on both the RTC client and the RTC server.
Figure 4 Network diagram
Procedure
1. Configure the RTC server:
IP network
RTC Client RTC Server
Central terminal Remote terminal
Async2/2/0
GE1/0/1
10.111.0.12
GE1/0/1
10.111.95.10
Async2/2/0