8
Figure 5
Installing an interface card
NOTE:
When tightening the captive screws at both sides of the interface
card with a screwdriver or an electric screwdriver, make sure the
torque is not bigger than 0.4 N-m.
Removing an interface card
1.
Put on an ESD-preventive wrist strap and make sure the strap is in
good contact with your skin and is properly grounded.
2.
Use a Phillips screwdriver to loosen the captive screws at both
sides of the interface card until all spring pressure is released. (See
callout 1 in
)
3.
Hold the ejector levers at both sides of the interface card and push
them outward. (See callout 2 in
) Pull the interface card
along the guide rails until it completely comes out of the switch
chassis. (See callout 3 in
.)
1
2
3
3
2
