Manual version: 6PW103-20141219
BOM: 3123A0MR
v
Figure 2 Installing the card
5.2
Removing the card
1.
Use a Phillips screwdriver to loosen the captive screws at both sides of the card.
2.
Pull the ejector levers at both sides of the card outward to separate it from the backplane, and then
pull the card along the guide rails to remove it from the chassis.
3.
Place the card on an anti-static workbench with the surface-mounted components up. You can also
put it in an anti-static bag.
4.
If you are not going to install a new card, install a filler panel to prevent dust and ensure good
ventilation in the switch.
6
Logging in to the card
The card uses an independent operating system. Before you can configure the card, you must log in to
the card by using one of the following methods:
•
Log in from the switch's CLI through the
oap connect
command.
•
Log in through the card's Web interface, console port, Telnet , or SSH.
H3C recommends that you log in to the card from the switch's CLI the first time you access the card. This
section includes a procedure for logging in from the switch's CLI. For more information about other login
methods, see
H3C SecPath Series Firewalls and UTM Devices Configuration Guides
.
