Manual version: 6PW103-20141219
BOM: 3123A0MR
iv
LED Status
Description
System LED (RUN)
Off
No power is input, or the card is faulty.
Steady green
The system is not operating correctly.
Flashing green (1 Hz)
The system has started up and is operating correctly.
Flashing green (8 Hz)
The system is loading the software or is not ready.
Combo interface LED
(LINK/ACT)
Off
No link is present on the port.
Steady green
A link is present on the port.
Flashing green
The port is sending or receiving data.
5
Installing and removing the card
CAUTION:
•
Wear a well-grounded ESD wrist strap or ESD gloves before you install or remove the card.
•
Do not touch the components on the PCB.
5.1
Installing the card
1.
Remove the filler panel from the slot for the card at the front of the switch.
This example uses slot 7.
2.
Place the card vertically with the surface-mounted components facing left. Pull the ejector levers
outward, and then gently push the card in along the slot guide rails until the card is in close contact
with the backplane.
3.
Push the ejector levers inward.
4.
Tighten the captive screws with a Phillips screwdriver to secure the card in the slot.
