2-19
Figure2-18 Installing an interface module with ejector levers
Installing interface subcards
CAUTION:
If you are not to install an interface subcard in a slot on an interface module, keep the filler panel in
the slot.
For the interface subcard compatibility with interface modules, see "Appendix B FRUs and
compatibility matrixes."
To install an interface subcard:
1.
Wear an ESD wrist strap. Make sure the wrist strap makes good skin contact and is reliably
grounded.
2.
Remove the filler panel from the target slot on the interface module.
Keep the removed filler panel secure for future use.
3.
Correctly orient the interface subcard and open the right ejector lever of the interface subcard.
4.
Insert the interface subcard into the slot and push it steadily into the slot along slide rails.
5.
Continue to push the interface subcard by its middle part on the front panel until you cannot
push it any further.
6.
Close the right ejector lever until it comes in close contact with the front panel.
