Manual Version:5PW100-20120627
5
Figure 5
Attaching the antenna to one mast-mount clamp
4.
Position the antenna on the mast so the mast mount clamp makes close contact with the mast. Place
the other mast-mount clamp on the mast and pass two M6 bolts through the holes on the
mast-mount clamps. Start a nut on each end of the bolts and tighten the nuts with an adjustable
wrench until the mast-mount clamps are secured in place. See
Figure 6
Mounting the antenna to the mast
5.
Use a cable to connect the AP antenna port with the N-K connector on the antenna.
To change the horizontal orientation of the antenna, adjust the mast-mount clamps.
To change the vertical orientation of the antenna, adjust the antenna bracket.
6.
Weatherproof the antenna:
a.
Fasten all nuts and screws again until the antenna is secured in place.
b.
Use a sealant tape to weatherproof the connector.
c.
Use a cable tie to bind the three cables to the mast. See
.
