H-Tec DEMO House, Operating Instructions Manual

Page: 15 / 28

www.myhtec.com
1 5
Fig. 7: Replacing the graphics
n
1. Remove the implied solar module.
n
2. Loosen the upper screw at the gable end of the demonstration model and remove it. Screw,
nut and washers must be stored safely.
n
3. Carefully pull the graphic front side and the graphic rear side out from above one after another.
n
4. Carefully insert the new graphics and make sure not to damage the surfaces.
n
5. Insert the screw with a washer again and fix it with a second washer and the nut.
NOTICE Tightening the screws
Excessive tightening of the screws may cause damage to the
product.
n
6. Put on the implied solar module again.
Replacing the graphics
The graphics of the demonstration model “DEMO House” are available in different language versions
and can also be designed individually. This is why they are replaceable.
The graphics are replaced as follows.
2
5
3
4
6
1