Danze, Inc. / 2500 Internationale Parkway / Woodridge, IL 60517
www.hcwaterware.com
2
INSTALLATION, CARE AND CLEANING
INSTRUCTIONS
FOR YOUR NEW
Pull Out/Pull Down Kitchen Faucet
BEFORE YOU BEGIN: Read this important
information.
1. Shut off main water supply before installation.
2. Check to make sure you have the following parts
indicated below:
Step 1. Install Faucet
A. Install faucet body through top of sink.
NOTE:
For
3-Hole installation,
the deck plate
for Pull Out (DH455010,DH455020) is optional.
If needed, refer to drawing A-2 (Place silicone
sealant beneath the plastic gasket during
installation).
Tools and Supplies you will
need to complete your
installation
A-1.
A-2.
2.
1.
4.
4.1.
4.2.
4.3.
3.
DH454530 Shown
1-Hole Installation
3-Hole Installation
1. Spray Head
2. Spout Assembly
3. Metal Handle Assembly
4. Mounting Hardware Assembly
4.1. Rubber Washer
4.2. Metal Washer
4.3. Lock Nut
Adjustable
wrench
Pipe tape
Phillips
screwdriver
Groove joint
pliers
Hex wrench
Silicone
sealant
Supply hoses or tubes
with1/2” coupling nuts to
connect faucet to water
supply valve
NOTE:
DO NOT REMOVE SPRING CLIP
FROM HOSE UNTIL STEP 2-D.
Optional deck plate (to cover existing
mounting holes in the sink deck).
