GYS MULTICOOL 1300, Manual

Page: 13 / 48

EN
13
Operating manual
POWER PACK 1300
Translation of the original
instructions
FLASHING GREEN LIGHT:
No lights on,
no warning buzzer:
The vehicle’s battery is low
(between 1 V and 9 V). Press
the “BOOST” button, wait for the
flashing GREEN indicator light to
turn solid, then turn on the cable
indicator within 30 seconds.
The vehicle’s battery may be dam-
aged (< 1 V). After making sure
that the clips are properly connect-
ed, press the “BOOST” button, wait
until the GREEN LIGHT is on, then
start the vehicle’s engine within 30
seconds.
4. Starting a vehicle
Do not attempt to jump start the vehicle more than three times in a row. This could cause dam-
age if the unit overheats. Wait for at least two minutes between each attempt.
The jump lead may overheat. If this occurs, a safeguarding system will cut off the voltage to the
jump-lead’s clamps.
5. After having started the vehicle, remove the jump leads from the vehicle’s battery. Leave the vehicle’s engine running.
Remove the jump-start clamps from the vehicle’s battery within 30 seconds of starting the engine.
Otherwise, damage may occur.
CHARGING THE POWER PACK 1300
1) Use the mains charger supplied with the machine.
1. Connect the charger port to one of the POWER PACK 1300’s 12 V - 30 V DC inputs.
2. Connect the other end of the charger to a 230 V power outlet.
3. Let the POWER PACK 1300 recharge (eight hours max.) then disconnect it by working backwards through the afore-
mentioned instrustions.
2) Using solar panels (not supplied)
The 12 V / 30 V DC inputs can support the energy of up to two solar panels (200 W max.).
1. Place the solar panel(s) in direct sunlight without exposing the POWER PACK 1300 to direct sunlight or moisture.
2. Connect the solar panel’s output to the 12 V DC input port.
Repeat the operation if a second solar panel has also been used.
3. Let the POWER PACK 1300 recharge and then disconnect it.
3) Using a car charger (not supplied)
1. Plug the electric-vehicle charger cable into the 12 V - 30 V DC input.
2. Plug the other end of the electric-vehicle charger cable into the car’s 12 V cigarette-lighter socket.
3. Allow the POWER PACK 1300 to recharge (for between 10 - 11 hours), then disconnect the machine.