7
GENEGYS 510 SF and GENEGYS WSF machine can be used with a WIRE in reversed polarity by inversing in face
before the connection of the earth clamp and bank.
4-4) Connection of the torch
All torches are with a euro connection, which can be adapted on GYS machines.
4-5) Setting of rollers
Choose those in function of the wire diameter used and the type of wire (See following board). MAGYS 410
machine is delivered with rollers double groove 0,8 / 1 for steel.
4-6)
Setting of wire spool
Open the wire feeder compartment. Remove the swivel from the coil support. Take the coil and put it on the support
with taking care to block with base spin, then screw down again the swivel. For an application with a 5Kg coil (or
d=200), put the adapter between the support and the coil. For an application in steel wire place in position the
capillary tube (for an application in aluminium see the paragraph VIII).
Slump the wire in the moto wire feeder entrance. Release the clamping at maximum. Close the plate of the moto wire
feeder. Press on « ADVANCED WIRE » (in foreside) and tighten little by little the clamping handle until the motor
start to drive the wire.
4-7) Brake adjustment from the coil support
You must block this one in function of the weight coil used.
Too blocked: the motor is in difficulty and the WIRE risk not to drive.
1
4
3
2
