6
I
V / COMMISSIONING
4-1) Mains connection
See paragraph III.
4-2) Connection to gas bottle and gas choice
Screw down the regulator on gas bottle. This one is connected to MAGYS and GENEGYS by a pipe whose terminal
end is fixated on the electronic valve behind the machine. You must use clamps to avoid escape of gas.
MAGYS 410
Application with the wire feeder of the generator
Application with a separated wire feeder typ WF
Screw down the gas connection from moto generator
wire feeder on the gas connection
Screw off the pipe of moto generator wire feeder and screw
down bank connection by integrating the pipe in the frontside
hole.
For GENEGYS 510 SF and GENEGYS 515 WSF machine, the gas connection of the bank is uniquely made on front
side.
Gas choice:
STEEL MORE OR LESS ALLOYED
-
Pure CO2 (not much used),
-
Argon + CO2 (universal gas, often used),
-
Argon + CO2 + O2 (not much used).
STAINLESS STEEL
-
Argon + CO2 (often used),
-
Argon + H + CO2 +N (not much used).
ALUMINIUM
-
Pure argon (often used),
-
Argon + Hé (not much used).
4-3) Connection to earth cable
For an application with a wire in normal polarity, you must connect the adapter earth clamp on the negative terminal
and take care to swivel from a ¼ the adapter.
MAGYS 410 machine can only operate in normal polarity (positive for the motor) if we used the generator wire
feeder.
