16
PROTIG 200 DC HF
EN
Translation of the original instructions
USE WITH EXTENSION CABLES
All extension cables must have an adequate size and section, relative to the machine’s voltage .
Use an extension that complies with national safety regulations.
Input voltage
Length - Extension selection
< 100m
PROTIG 200 DC HF
230V
2.5 mm²
SYMBOLS & MENUS
FUNCTION
PICTOGRAM
TIG
DC
MMA
Comment
HF ignition
X
TIG process with HF ignition
Lift ignition
X
TIG process with LIFT ignition
Pre-gas
X
Time to purge the torch and to protect the area with gas before ignition
Up slope current
X
Up slope current
Welding current
X
Welding current
Courant froid
X
Second welding current or «cold» current in standard 4TLOG or in PULSE
mode
PULSE Frequency
X
X
PULSATION frequency of the PULSE mode (Hz)
Down slope current
10
s
20
s
0
s
X
Down slope current to minimum current, I Stop (S) to prevent weld defects
and craters.
Post gas
X
Length of time in which gas is released after the arc has stopped. It protects
the weld pool and the electrode against oxidization when the metal is cooling
(S).
HotStart
X
Adjustable overcurrent at the beginning of the welding (%)
ArcForce
X
Overcurrent delivered to avoid sticking when the electrode enters the welding
pool
TIG PULSE
X
Pulse mode
TIG SPOT
X
Spot mode
MMA PULSE
X
MMA process in PULSE mode
2T
X
2 time torch mode
4T
X
4 time torch mode
4T LOG
X
4 time LOG torch mode
Ampere (unit)
A
X
X
Amperes unit for welding current settings
Volt (unit)
V
X
X
Volt unit for displaying welding voltage
Second or Hertz (units)
S / Hz
X
X
Seconds or Hertz unit for time or frequency settings
Percentage (unit)
%
X
X
Percentages unit for proportionate settings
Display switch A or V
A
V
X
X
Switches the display of voltage or current during and after welding
Program menu access
MEM
PROG
X
X
Access to configuration menu (SAVE, JOB, ...)
Thermal protection
X
X
Standard symbol to indicate the thermal protection state
Sleep mode
X
X
Sleep mode