28
PLASMA CUTTER 85A / 125A
EN
Speed
Angle
Torch-part gap
GROOVE SHAPE
You may alter the groove’s shape by changing the torch’s speed, the distance or the
torch’s angle.
CHANGING THE GROOVE’S SHAPE
WISH
Width
Depth
Solutions
Accelerate
the speed
Reduce the
speed
Increase the
torch-part
gap
Decrease the
torch part
gap
Raise the
angle
Reduce the
angle
Increase the
current
Decrease the
current
CONSUMABLES INSPECTION (ASSEMBLY AND DISASSEMBLY, SEE P.24)
Parts
Actions
Solutions
Shield
Visually check the shield’s internal hole.
Check for fragments that may have accumulated in
the shield.
OK
NOK
Replace the shield if the hole is not round anymore.
Eliminate all superfluous materials.
Shroud
Check the for damage and surface wear.
Replace the shroud when it looks damaged (traces of
burns).
Tailpipe
Visually check the tailpipe’s internal hole.
OK
NOK
Replace the tailpipe if the inner diameter is enlarged
or distorted.
Diffuser
Check for damage and wear on the surface and inside
the diffuser.
Check that the fumes’ exhausts are not obstructed.
OK
NOK
Replace the diffuser if the surface is damaged or
worn, or if fume exhausts are obstructed.
Electrode
Visually check the electrode’s internal hole.
OK
NOK
Replace electrode when the insert is used (removal of
1.5 mm).
ERROR ICONS
Error codes appear whenever a problem is detected. These are classified by 2 digits codes
(Error type + error code) referring to the table below.
Only the error code with the highest priority appears on the screen.
Communication
Informs the user that an error has occured in the internal bus.
Warning
The machine keeps functioning. The user must interact with the machine to rectify the fault.
Thermal
The heat sink’s temperature is outside the acceptable operating range.