GYS 029675, Manual

Page: 6 / 32

6
GYSFLASH 1.12 LITHIUM
SAFETY INSTRUCTIONS
This manual contains safety and operating instructions, to be followed
for your safety.
Please read it carefully before using the device for the first time and
keep it in a safe place for future reference. This machine should only
be used for charging operations specified within the limits indicated
on the machine and in the instruction manual. The operator must
observe the safety precautions. In case of improper or unsafe use, the
manufacturer cannot be held liable.
This unit can be used by children aged 8 or over and by people with
reduced physical, sensory or mental capabilities or lack of experience
or knowledge, if they are properly monitored or if instructions for
using the equipment have safely been read and risks made aware of.
Children must not play with the product. Cleaning and maintenance
should not be performed by an unsupervised child.
Do not use to charge domestic batteries or non rechargeable batteries.
Do not operate the device with a damaged power supply cord or a
damaged mains plug.
Do not use the device if the charging cable appears to be damaged
or assembled incorrectly in order to avoid any risk of short circuiting
the battery.
Never use on a frozen or damaged battery.
The operating mode of the automatic charger and the restrictions
applicable to its use are explained later in this manual.
Fire and explosion risks!
• Avoid flames and sparks. Do not smoke near the device.
• Protect the electrical contacts of the battery against short-circuiting.
Connection / disconnection :
• Ensure that the charger’s power supply is disconnected before
connecting or disconnecting to the battery terminals.
• Always ensure the Red clamp is connected to the «+» battery terminal
first. If it is necessary to connect the black clamp to the vehicle chassis,
make sure it is a safe distance from the battery and the fuel/exhaust
pipe. The charger must be connected to the mains.
• After charging, disconnect the charger from the mains, then
disconnect the negative clamp from the car body and then disconnect
the positive clamp from the battery, in this order.
Connection :
• Class II device
• The connection to the power supply must be carried out in compliance
with national standards.
EN