Gymrex GR-MG 57, User Manual

Page: 21 / 104

a) Attach the machine bases (3, 4) to the side frames (1, 2). For this purpose, use
M12x135 bolts, M12 washers and M12 safety nuts. Align the bracket base and
fastener hole axes. Slide the washer onto the fastening screw. Insert the
previously prepared fastener into the hole axis from the floor side. Secure with
a washer and nut from the top. Repeat the procedure for all holes.
b) Connect the assemblies prepared as above with the lower fastener (5). For this
purpose, use M12x75 bolts, M12 washers and M12 safety nuts. Guide the
screw from the outside. Fasten in a similar manner.
c) Place the stabilising fastener (6) between the side frames (1, 2). Place the right
load holder (8) from the outside of the right frame (1). Align the axes of the
fastener, frame and holder. Attach the assemblies routing the fastening screw
from the outside. Use M12x140 bolts, M12 washers and M12 locknuts.
Assemble the left frame elements in a similar manner.
d) Place the upper frame stabiliser (7) between the side frames (1, 2). Align the
axes of the left and right frame holes and the stabiliser hole. Fasten with
M12x75 screws, M12 washers and M12 nuts. Guide the screws from the side
of the external side frames.