(1) Power input: The total power provided by the product for PoE supply, i.e. the
power provided by built-in 54V power, has been set up when it leaves the factory,
please do not modify it. If users modified the power supply, please correct this
setting. If the setting value is larger than the actual power of the built-in power
supply, there will be a damage of built-in power. If the setting value is smaller than
the actual power of built-in power supply, built-in power supply could not be fully
allocated out.
(2) Allowing maximum overload: built-in power allows overload value setting range
is 0%-10%, default is 5%. If actual power is too large that cause built-in power
overload exceeding setting value, the system will turn off power supply of low
priority ports. For example:when input power is 360w, maximum overload is 5%.
when actual output power exceeds 360*(1+5%)=378w , the system overloads.
(3) Power Reservation: power reservation could not be contributed, but be used for
PoE equipment consumption due to load changes. Default power reservation is
15% of total power. The higher the value, the slower the risk of system overload, the
power to be contributed decreases, and the number of PoE equipments to be
connected decreases; on the contrary , the more the number of PoE equipments to
be connected, the higher risk of system overload.
(4) Operation instructions: after setting the value, press <OK> button. Setting
succeeds when the following window pops out.
3.3.2.9 Power Status
Power status page diagram
The input power, allowing maximum overload and reserved power have
been set up before the product leaves the factory. User is allowed to modif
it, prudently.
3.3.2.8 PoE Setting
Diagram of PoE setting page
3 3 2 5 Restore IP Address and Login Password
. . .
Start the product, unplug the network cable of console port, then press init
key(3
～
5 seconds), till the RJ45 LED light of console port flash once, the IP
address and login password will be restored to the initial setting.
3 3 2 6 Equipment Information
. . .
Click menu bar [equipment information] on Web page , then three product
information of [IP address], [MAC address] and [software version] will be popped
out for user checking. After review, click <Exit> to log out checking status.
Equipment information diagram
3 3 2 7 Exit
. . .
Click
main
menu
[
Exit
]
to
return
to
login
page
.
Diagram of restore IP address, login password
17
18
Instruction
PoE Output Ports
PoE
Web
Management
Port
PoE
Output
LED
Reset
PoE Output
Percentage
LED