![background image](http://html1.mh-extra.com/html/guzzanti/8594186721290/8594186721290_instruction-manual_2279504226.webp)
30
3. CARING FOR YOUR MACHINE
REPLACING MOVING CUTTER
Replace a moving cutter if it becomes blunt as follows. A spare cutter will be found in your accessories.
NOTE:
You should not need to replace fixed cutter, which is made of special hard alloy material.
FIRST REMOVE THE POWER PLUG FROM THE SUPPLY SOCKET-OUTLET.
1. Loosen screw and take out moving cutter.
2. Close the working table. Lower cutter driving
arm to its lowest position by turning the hand
wheel towards you by hand. In this position,
set replacement cutter in position and secure it
with screw, ENSURING THAT THE EDGE OF THE
MOVING CUTTER IS APPROXIMATELY 0.5 MM
BELOW THE SURFACE OF THE FIXED CUTTER.
DISENGAGING MOVING CUTTER
If you want to sew without cutting, open the
working table and disengage the moving cutter
by pushing the cutter release knob to the left
and turning it towards you as illustrated. Ensure
that fabric edge is not wider than overedge width
selected or upper looper and needle can be
damaged.
REMOVING FACE COVER
Disconnect from power supply before removing
face cover.
Remove the screw and take off the face cover.
F(
9
Screw
Moving cutter
Cutter release knob
Face cover
Screw