10
LINT TRAY
With the lint tray located in this position it will
collect all your waste material.
After completion of work if you then turn tray
upwards in direction shown, finger Ref C will
locate in slot D and left hand pin will slide into
lower hole B.
CUTTING WIDTH GAUGE
When using cutting width gauge,the fabric is cut
down and sewn at same distance from the edge
of fabric.
Within the distance of the width adjusted.
THREAD CUTTER
Thread cutter is built in face cover. Draw materials
to the rear and cut off excess thread with the
thread cutter located on the bottom of face cover
as shown.
CHANGING PRESSER FEET
Be sure needleis in the up position.
Raise presser foot lever.
1. Push foot release lever to remove the foot.
2. Place the desired foot on the needle plate
aligning needle holes.
3. Lower the presser foot lever and push foot
release lever so that the foot holder snaps on
the foot.
E
%
Foot release lever