39
Residual heat indication
After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don’t touch the heating zones and don’t put any
heat sensitive object on them.
There are risks of burn and fire.
Booster and Twin Booster function
Booster[ P ] and Twin Booster [
] grant a boost of Power to the selected heating zone.
If this function is activated the heating zones work during 10 minutes with an ultra high Power.
This is foreseen for example to heat up rapidly big quantities of water, like nuddles
Start up / Stop the Booster:
Action
Control panel
Display
Start up the Booster
Slide to the end of the “SLIDER”
[ P ]
Or press directly on the end of
the “SLIDER”
Stop the Booster
Slide on the “SLIDER“
[ 9 ] to [ 0 ]
Start up / Stop Super Power
Action
Control panel
Display
Start up the Booster
Slide to the end of the “SLIDER”
[ P ]
Or press directly on the end of
the “SLIDER”
Start up Twin Booster
Re-press key [ P ]
[
and P ]
Stop the Twin Booster
Slid
e on the “SLIDER“
[ P ] to [ 0 ]
Stop Booster
Slide on the “SLIDER“
[ 9 ] to [ 0 ]
Power management:
The hole cooking hob is equipped with a maximum of Power. When the Booster function is
activated, and in order to exceed the maximum Booster, the electronic system orders to reduce
automatically the power level of an other heating zone. The display is blinking on [ 9 ] during a
few seconds and then shows the maximum of power allowed :
Heating zone selected
The other heating zone:
(example: Booster level 9)
[ P ] is displayed
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Timer
The timer is able to be used simultaneous with all heating zones and this with different time
settings (from 0 to 999 minutes) for each heating zone.
Setting and modification of the cooking time :
Action
Control panel
Display
Select the power level
slide on the “SLIDER“
[ 1 ] to [ P ]
Select theTimer
Press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Decrease the time
Press key [ - ] from the timer
[ 60 ] to 59, 58...
Increase the time
Press key [ + ] from the timer
Time increase
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.
Summary of Contents for 11C800I
Page 1: ...GEBRAUCHSANWEISUNG NOTICE D UTILISATION INSTRUCTION OF USE 11C800I ...
Page 2: ......
Page 47: ......
Page 48: ...15445 0 ...