INSTALLATION
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective plastic film, packing materials and accessories
from the Appliance before connecting electrical power or otherwise performing any installation procedure.
Carefully read all instructions in this manual and the Installation Instruction Sheet packed with the appliance before
starting any installation.
Read and understand all labels and diagrams attached to the appliance.
Carefully account for all components and accessories before discarding packing materials. Store all accessories in a
convenient place for later use.
COMPONENTS
1
FRYPOT
2
FRY BASKETS
4 ea. RUBBER FEET
SETUP
Setup the appliance only on a firm, level, non-combustible surface. Verify local codes for requirements. Concrete,
tile, terrazzo or metal surfaces are recommended. Metal over combustible material may not meet code for non-
combustible surfaces.
With a spirit level, check that the appliance is level front-to-back and side-to-side. Verify that the unit sits firmly on
ALL FOUR LEGS or rubber feet.
The lower portions of the legs are adjustable by turning; adjust as required to level the appliance. All four rubber feet
must be adjusted to firmly contact the counter in order to prevent tipping or rocking.
Avoid storing flammable or combustible materials in, on or near the appliance.
IMPORTANT:
This installation must comply with all applicable Federal, Local and NFPA codes.
FRYER ELECTRICAL INSTALLATION
This fryer is equipped with a cord and plug, and requires a properly installed
matching receptacle. Contact a licensed electrician to install an appropriate electric
circuit and grounded receptacle.
Be sure the TEMPERATURE CONTROL KNOB is turned to the OFF position, then
plug the POWER CORD into the proper receptacle.
ELECTRIC SHOCK HAZARD
The ground pin of the power cord plug is part of a system designed
to protect you from electric shock in the event of equipment
damage.
DO NOT
cut the ground pin from the power cord plug in order to fit an existing receptacle;
DO NOT
twist a blade of the power cord plug in order to fit an existing receptacle.
Contact a licensed electrician to install an appropriate electrical circuit and receptacle.
Above: Fryer Power Plug and
Receptacle Configuration
CAUTION
