Operating Manual
Operation
3/10/04
9
OPERATION
WARNING:
N
EVER POINT THE GUN AT OR NEAR OTHER PERSONNEL OR PLACE ANY PART OF
THE BODY IN THE PATH OF THE MATERIAL SPRAY
. D
O NOT LOOK INTO THE DISPENSING END OF
THE GUN
. A
LWAYS ENGAGE THE
S
AFETY
S
TOP AND CLOSE BOTH MANUAL VALVES WHEN NOT
USING THE GUN
. D
O THIS TO AVOID THE POSSIBILITY OF BODILY INJURY OR PROPERTY
DAMAGE FROM THE ACCIDENTAL OPERATION OF THE GUN
.
Safety Stop Operation
The GAP PRO Gun has a two position
Safety Stop. When engaged, it prevents
accidental triggering of the gun during
servicing or down time. When disengaged,
it allows the gun to dispense.
1.
TO ENGAGE THE SAFETY
STOP-
Push in and turn the Safety
Stop knob clockwise to place the gun
in the Safety detented position.
Figure 3. Engage the Safety Stop
IMPORTANT
: Always engage the
Safety Stop when the gun is not in use.
2.
TO DISENGAGE THE SAFETY
STOP-
Push in and turn the Safety
Stop knob counterclockwise to place
the gun in the Open detented position.
Figure 4. Disengage the Safety Stop
Manual Valve Operation
The manual valves located on the each
Side Block control the flow of each
chemical component to the gun.
TOOLS REQUIRED
•
5/16” Nut driver
1.
TO OPEN MANUAL VALVE
-
Using the 5/16” nut driver, turn
manual valve counter clockwise
approximately three full turns.
WARNING:
N
EVER OPEN A MANUAL VALVE
UNLESS THE
S
IDE
B
LOCK IS SECURED TO THE
G
UN
,
OR THE EXIT PORT IS DIRECTED INTO A
SUITABLE CONTAINER
.
Figure 5. Manual Valves
NOTE:
Triggering of the gun with the
manual valves closed may cause
crossover if there is any residual
chemical in the gun ports.
2.
TO CLOSE MANUAL VALVE
- Using the 5/16” nut driver, turn manual valve
fully clockwise.
WARNING:
T
O PREVENT ACCIDENTAL GUN OPERATION
,
ALWAYS ENGAGE THE SAFETY STOP
,
CLOSE BOTH MANUAL VALVES AND DISCONNECT THE AIR SUPPLY BEFORE SERVICING THE GUN
,
OR ANY TIME THE GUN IS NOT IN USE
.