GULLCO Pipe Kat PK-500-LG Series, Operating Instructions Manual

Page: 38 / 54

34
CARRIAGE CONTROL PROGRAMMING
There are two levels of programming

General Programming Mode: this first level of programmable features is meant to be
easily accessible to the operator and requires that the Program push button be
pressed for a minimum of one (1) seconds, but no more than seven (7) seconds.
The screens that are accessible under this mode are:
o
Screen 1:- Shielding gas preflow/Wire feed soft start speed.
o
Screen 2:- Travel-Dly/Crater-Fill/Burn-Back/Post-Flow.

Advanced Programming Mode: this second level of programmable features is meant
only to be used by higher level and/or qualified users and requires that the Program
push button be pressed for more than ten (10) seconds. The screens that are
accessible under this mode are:
o
Screen 1:- Units (inch or Cm)/Vert_Speed/Buzzer Duration.
o
Screen 2:- Carriage motor parameters.
o
Screen 3:- Wire Feeder motor parameters.
o
Screen 4:- Welding power source calibration.
o
Screen 5:- Error code screen.
To change state from either programming mode (any screen) to running (operational) mode,
press the Programming Button for one (1) second or longer. The various values and settings will
be saved.
When in programming mode:

The “Auto Cycle Stop” push button is used to navigate forward and backward
between screens (pages)

The “Carriage Weld Speed” rotary switch is used to navigate forward and
backward between adjustable fields of the current screen (page). The contents of
the selected field will flash to indicate which field is currently selected.

The “Wire Feed Speed” rotary switch is used to change the value/setting of the
currently selected adjustable field.

The Programming Button is used to save all values and settings, exit
programming mode and return to the running (operational) mode.
While-ever the control is in programming mode, the program icon is displayed in the lower right
hand corner of the LCD screen as follows: