10
.
REMOTE PAIRING PROCESS
Make sure to turn off power at breaker box.
Disconnecting wire from #2 fan.
OF
F
OF
FO
FF
OFF
Turn on power at breaker box and #1 Fan is ready for pairing.
OFF
OFF
OFF
ON
Before starting the remote control setting process, lower the canopy of #2 Fan and disconnect the Black wire.
Put the wire nut on the black wire from the house.
#1 Fan
is ready for setting.
A fan may need to have “Pairing Process” performed for the following issues.
1. Replacing the transmitter.
2. Replacing the receiver.
3. Multiple fans on the same circuit.
(In multiple fans situation, each fan must be wired up individually for the Pairing Process;
see step 10-1.
)
P9
1. Switch off the main power and make sure fan has completely stopped .
2. Install a New receiver or install the battery in a new transmitter before the Pairing Process.
3. Switch on the power again, and immediately:
This process must be done within 20 seconds after switching on the power.
This fan has completed the pairing successfully and the fan is ready for operation!
Press and hold the Fan On/Off button
for
8 seconds until the Receiver “Long Beeps”.
OF
F
OF
FO
FF
OFF
10-2A. Pairing Process for Multiple fans (One transmitter for multiple receivers)
If you wish to use only
one transmitter for two fans
, simply wire up both fans at one time
and perform the Pairing Process at
step 10-1
from a point between the two fans.
The Pairing Process is only necessary when there is an issue. Remote set is pre-paired from the factory and
should not require the Pairing Process.
10-2B. Pairing Process for Multiple fans (One transmitter for one receiver)
The Pairing Process must be performed on each remote set (transmitter and receiver) individually.
See the set up at step 10-3.
10
-
3. TO SET UP REMOTE FOR #1 FAN
(operating now)
*See the remote control setting process
10-1 to set up #1 Fan.
Outlet Box
#1 Fan
Outlet Box
#2 Fan
Outlet Box
#2 Fan
(Disconnecting)
Canopy
Mounting Bracket
Outlet Box
#1 Fan
10-1. PAIRING PROCESS FOR TRANSMITTER AND RECEIVER: