Guldmann 12075-000, Manual

Page: 6 / 16

6
Slide the end stop back to the mark. Unscrew the screw (1) next to the rub-
ber knob of the end stop and fit the spring retainer (2) into the opening of the
rail undeneath the end stop. The opening of the spring retainer must face the
hoist. The foam rubber disc (3) must be positioned at the bottom end of the
spring retainer (4) behind the screw. Tighten the end stop.
Connect the conductor housing to the charger and check the function.
The positioning of the conductor housing could be marked by means of the
enclosed labels with charging symbols.
1 .07 . Mounting .of .charging .station .in .the .traverse .rail .system .
When charging in the traverse
rail system, two conductor hou-
sings, one for the traverse rail
and one for the parallel rail are
employed. Furthermore, one
current receiver is employed in
addition to the current receiver on the hoist.
The above mounting instructions apply for the mounting of the conductor hou-
sing in connection with trolley for traverse rail. However, no spring retainer is
to be mounted.
Before mounting the trolleys for traverse rail, position the current receiver on
one of the trolleys for traverse rail and make sure that it will face the chosen
position of the conductor housing.
Fit the current receiver to the hanger at the end of the trolley and push it into
position in the eye of the hanger. The solderings of the current receiver must
turn away from the trolley.
Check .that .the .wire .is .secured .in .the .hooks .placed .at .the .bottom .of .the .
current .receiver .
After mounting the traverse
rail, mount the conductor
housing of the hoist as shown
in the instructions, and con-
nect it to the current receiver
on the trolley for traverse rail.
The marked wire is the + con-
ductor. (The + conductor of
the conductor housing is con-
nected to the + conductor of
the current receiver)
Stick the wire underneath the trolley for traverse rail by means of double
sided adhesive tape.
Connect the conductor housing to the charger and check the function.
The positioning of the conductor housing could be marked by means of the
enclosed labels with charging symbols.
If service/repair should be necessary, the conductor housing and charging
station for the room-covering system can be dismounted and exchanged
without dismounting the rail system. For servicing of the current receiver it is
necessary to remove the hoist and/or the travelling trolley from the rail.
©
G
ul
dm
an
n
G
B
-8
96
/0
8/
08
•
#
9
00
66
©
G
ul
dm
an
n
G
B
-8
96
/0
8/
08
•
#
9
00
66