Customer Helpline 0333 3201989
12
Operating Instructions
11� BASE PLATE ANGLE ADJUSTMENT
Use an Allen key (5). Loosen the bolts securing the base plate (SEE FIG J). For preset
angles rotate so the lines of the angle on the base plate and angle plate (8) superposition
at the desired angle (0°, 15°, 30°, 45°) (SEE FIG K). For other mitre angles, rotate to your
desired angle (use a protractor scale). Following one of the above procedures, hold the base
plate in position and firmly tighten the bolts to clamp the base plate at that angle. Finally,
check the angle and ensure the base plate is firmly clamped. The angle markings on the
base plate are accurate for most general purposes but it is recommended for accurate
work to set the angle with a protractor and make a test cut on other material.
12� DUST TUBE (SEE FIG L)
Mount the dust tube (6) into the opening of the base plate (7). Make sure that the plastic
tip of the vacuum connection engages into the corresponding opening on the housing as
shown in the figure.
6
7
8
J
K
L
