Guild PRG350G, Instruction Manual

Page: 8 / 16

Customer Helpline
0333 3201989
8
Operating Instructions
The table below shows recommended run-DIN-seconds for different types of material.
Solvent-based paints--------------------------------15-50
Primers---------------------------------------------25-50
Pickling----------------------------------no need to dilute
2 Component paints--------------------------------20-50
Varnishes------------------------------------------15-40
Waterborne paints---------------------------------20-40
Automotive topcoats--------------------------------20-40
Wood preservatives---------------------no need to dilute
If the paint takes longer than the recommended time to empty, then further thinning
is required. Mix in a small quantity of the appropriate thinner and use the viscosity test
until the correct thickness is achieved.
2. ASSEMBLING THE TANK
1) Remove the tank by unscrewing it in clockwise direction from the spray gun.
2) Fill the tank with paint of the correct viscosity.
3) Adjust the suction pipe direction correctly according to different operating conditions
to deplete the material in the tank as much as possible.
SPRAYING WITH A TILTING ANGLE:
Note:
Don’t tilt too much.
Spray to the underlying objects
- turn the suction pipe forwards. (SEE FIG. B1)
Spray to the overhead objects
- turn the suction pipe backwards. (SEE FIG. B2)
4) Fill the tank with prepared paint.
5) Assemble the tank back to the spray gun by screwing it tightly in counter-clockwise
direction.
B1 B2