Customer Helpline
0333 3201989
9
Operating Instructions
OPERATION
1. ON/OFF SWITCH (SEE FIG. C)
To start the tool, depress the on/off switch to “I”.
To stop the tool, depress the on/off switch to “O”.
2. TRIGGER SWITCH (SEE FIG. D)
Depress the on/off switch to “I”, then squeeze the trigger switch to start the spraying work.
3. SELECTING THE SPRAY PATTERNS (SEE FIG. E)
Unscrew the cup nut (9), and turn the air cup (10) to desired position to fit the different
operating conditions. Then re-tighten the cup nut.
Following figure shows the air cup position with their corresponding spraying patterns:
A: Air cup is in horizontal position = the spraying shape is vertical: for vertical surface;
B: Air cup is in vertical position = the spraying shape is horizontal: for horizontal surface;
C: Air cup is in oblique position =the spraying shape is circular: for corners, edges and others.
WARNING!
Never turn the air cup when trigger switch is depressed.
4. ADJUSTING THE RATE OF FLOW (SEE FIG. F)
The sprayed capacity can he adjusted by using the flow rate adjusting knob. Adjust the
adjusting knob until the best spray pattern is reached. Turn the adjusting knob clockwise (+)
to increase the flow rate and turn it counter-clockwise (-) to decrease the flow rate. A poor
spray pattern will concentrate the paint in the centre of the spray and give a blotchy finish. A
good spray pattern will give even distribution of paint throughout the pattern.
E
C
F
D
Summary of Contents for PRG350G
Page 16: ......
