§
§
§
Customer Helpline
10
Operating Instructions
Maintenance
11
11
Install and remove 12V car power supply
Unravel cord before use.
To install: Make sure the latch on the 12V car power supply
snaps into place and that it is secured in the tool before
operating, which is same as battery pack installation.
Connect the 12V car power supply plug into your car
cigarette lighter
When ready to use, always power your car on to avoid the
car battery running low.
To remove: Push the release button to release the car
power supply and remove it from the tools.
Note:
Always run a vehicle outdoors.
Install and remove accessories
1. Position the air chuck in the unlock position
2. Position the rear end of the accessory (airbed nozzle and
ball needle) into the opening
3. Clamp the end of the air chuck down onto the threaded
part of the accessory by pressing the air chuck down
until it stops.
Note:
The airbed nozzle can be used on smaller pinch
valves to inflate small items like children's toys, which usually
require the user to inflate them by blowing air into them.
The ball needle can be used to inflate any type of sports ball or any other items that requires an
inflation sport all needle. Wet needle with water to aid insertion will be better.
Note:
When inflating items of 10PSI or less, inflate in short bursts and check after each burst by feel
or with a calibrated measuring device to determine accurate pressure.
Note:
Pressure required for most sports balls is too low for an accurate reading on gauge.
6
5
10
7
8
15
10
10
7
15
8
7
0345 640 0800
5
6
