Page 12 of 13
condition of any booster pack be examined before it is used. Keep your booster pack in good repair.
Keep handles dry, clean, and free from oil and grease. The following chart is based on a normal
operation schedule.
Maintenance Interval
Maintenance Point
Before operating or after using
Clean the exterior surface of the booster pack with a damp
cloth to prevent accumulation of dust and dirt.
After using
Make sure inverter/USB/LED/DC are OFF
Make sure ON/OFF Power Switch to OFF position after use.
Make sure disconnecting the 12V DC appliances after use to
avoid over discharge of booster pack’s internal battery
Make sure the plastic covers on the 12V DC outlet are closed
after use.
Extending battery lifespan
Recharge the battery at least once every 90 days. This will
extend the durability and efficiency of the battery.
Troubleshooting
Use the table below to troubleshoot problems before contacting service personnel or your local
dealer. If the problem continues after troubleshooting, call your local dealer for assistance.
Failure
Possible Cause
Corrective Action
The power pack does not jump start
vehicle
That battery in the jump
starter is not fully charged.
Fully charge the power pack
The engine start
capacity exceeds the
power pack jumpstart
capacity
Use a higher capacity
Power pack.
Battery of the vehicle
is damaged
Replace the vehicle
battery
No charging indication on LCD screen
when recharging
No AC power at the
AC wall outlet
Ensure power is available
at the AC wall outlet
The AC charger is
faulty
Replace the 115 V AC
charger
Not fully charged unit for more than 72
hours.
The output of the AC
charger is low.
Replace the 115 V AC charger.
Switches are in the “ON”
and a AC or DC
load is connected.
Place all switches in “OFF” position
and disconnect all loads.
